1. After inspection, clean the surface dirt of the equipment with clean water, wipe it clean with a clean towel, and put it back in its original position according to packaging requirements; Do not subject the device to compression, collision, or impact, which may cause unnecessary damage. Clean the camera window and display screen dust by using a clean cotton ball dipped in anhydrous alcohol and rotating it from the inside out to wipe;
2. Handheld wireless controllers should be charged in a timely manner. When not in use for a long time, they should be charged and discharged at least once every 3 months;
3. When the device is finished and the internal heat is high, it should be placed in the box for 5-10 minutes before entering;
4. At the end of each assignment, the dust cover corresponding to each joint should be covered;
5. After the control system has been working for 6 months, routine maintenance, replacement of cooling fans, and dust removal work should be carried out in a timely manner;
6. After the crawler has been working for 100 hours, the screws of the structural components should be tightened. If it is left for more than 6 months, the internal grease should be replaced and the sealing condition should be checked;
7. The front camera system is the same as above;
8. When using a 48V/8AH battery (optional), please charge the battery promptly in case of system undervoltage alarm. During the charging process, when the charger indicator light turns green, the charging is complete; When the battery is not used for a long time, it is recommended to charge and discharge it once every 1-3 months.

机械设备模板

Self service repair form

Company name or name*

Telephone*

Cell-phone number*

Fault situation*

Leaving a message